Avid Technology AS3000 Guia de Configuração descarregar pdf (Página 44)

Removing and Installing a Hot-swap Hard Drive

The following illustration shows the connectors on the bottom of the drive carrier.

Bottom View of Drive Attached to Drive Carrier

A. Drive connector

B. Screws

C. Latch

11. With the black lever in the fully open position, slide the drive assembly into the server

system. The latch at the front of the drive carrier must be on the right. Do not push on the

black drive carrier lever until the lever begins to close by itself.

Do not force a drive into a slot. If you are having problems installing a drive, check to make sure

it is level and flat as you insert it into the server, that the drive carrier latch is open and at a 45

degree angle to the drive carrier, and that the LEDs are on the bottom of the drive carrier.

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 82 83

Sem comentários

Avid Technology AS3000 Guia de Configuração Página 44